>> >> kernel: hda: dma_intr: error=0x84 { DriveStatusError BadCRC }
>>
>> MH> this can only be caused by bad cable/config. is it 18", with both ends
>> MH> plugged in?
>>
>>
>> Do you mean 40-pin E-IDE cable?
MH> 40-conductor cables are only valid to use up to udma33, but 80c cables
MH> will *always* help, and can be used in any mode. but equally important
MH> is that the cable must never be longer than 18", with both ends plugged in
MH> (no stub).
I measured the cable and it is aprox. 45cm (18") and it is 80c.
It has also 3 connectors, two of them are in use (on the ends), and
one is free (in the middle). I also checked the connections on
motherboard and on disk, they are both ok.
-----BEGIN PGP SIGNATURE-----
Version: 2.6
iQCVAwUAOrFfcT5SQymVx3NvAQEmwQP/bMQYXekwlUDKPdQ80khqfkv45TCY8lVd
r6lXb82s60vvbEpCTyF16E4TwQkwirsPf5virJ0jZO+EBFRVwOhDFitbaF9PdHhG
MdSFtST6JrhwozsoU3LgkdMZb3Mnnw7YsV9ctOZij+4WN5SDd5IO5YNXgeWgrdLb
c+jZzBpmLK8=
=PvVG
-----END PGP SIGNATURE-----
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/