We do not put ATAPI devices on such HOSTS.
The driver will not work w/ ATAPI there because it uses a different DMA
engine location and is not supported in Linux.
You will find greater success in putting your ATAPI device on the native
Linux Disk Certification Project Linux ATA Development
On Sat, 23 Feb 2002, Adam Huffman wrote:
> When I try to boot a kernel with the latest IDE driver in order to
> support my Promise UltraATA133 TX2 card, the system hangs at the point
> where it should be listing the two drives attached to the card i.e. it
> shows /dev/hdc which is a DVD drive, then stops. Sometimes I can reboot
> with Alt-SysRq, sometimes a hard reset is needed. This happens with
> 2.4.17+ide, 2.4.18-rc1, 2.5.5-dj1.
> Motherboard is MSI K7T-Turbo 2, K7 1.4, drives attached to the Promise
> card are an IBM 60GXP and a Maxtor D740X-6L. The drives work when
> attached to the VIA interface on the m/b.
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to firstname.lastname@example.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/