Re: Can't boot from /dev/md0 (RAID-1)

Juri Haberland (juri@koschikode.com)
Sun, 30 Jun 2002 15:35:12 +0200


Roy Sigurd Karlsbakk wrote:
>> I assume the onboard IDE stuff (hdm) is something like a Promise
>> controller. If so you should be able set the boot order to boot from the
>> normal IDE chipset (hda/hdb). If doesn't help I'd suggest that you ask
>> on the linux-raid mailing list.
>
> The on-board is a VIA controller. see from lspci
>
> 00:0c.0 Unknown mass storage controller: Promise Technology, Inc. 20268 (rev
> 02)
> 00:0d.0 Unknown mass storage controller: Promise Technology, Inc. 20268 (rev
> 02)
> 00:0e.0 RAID bus controller: CMD Technology Inc PCI0649 (rev 02)
> 00:11.1 IDE interface: VIA Technologies, Inc. Bus Master IDE (rev 06)

So you have your two raid drives connected to the VIA controller, right?
Then have a look into the BIOS setup and see, if there's something that
might affect the boot order...

> and - as for linux-raid, see below:
>
> ----- The following addresses had permanent fatal errors -----
> <linux-raid@vger.rutgers.edu>
> (reason: 550 5.1.1 <linux-raid@vger.rutgers.edu>... User unknown)

No wonder, vger.rutgers.edu ceased to exist ~2 years ago. Use
vger.kernel.org instead ;)

Juri

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/