Is this a bug in the ide device driver ? or is there any compatible HDD
list for 2.4.19 kernel ?
The cpu is PentiumIII 700Mhz cpu and
The chipset of motherboard is Intel BX.
The IDE controller is INTEL82801BA_9
In case of 2.4.19 kernel, the booting message as follows...
--
Linux version 2.4.19 (root@i74) (gcc version 2.95.4 (Debian prerelease)) #2
Wed
Oct 16 21:27:55 KST 2002
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 000000000bfeb000 (usable)
BIOS-e820: 000000000bfeb000 - 000000000bfef000 (ACPI data)
BIOS-e820: 000000000bfef000 - 000000000bfff000 (reserved)
BIOS-e820: 000000000bfff000 - 000000000c000000 (ACPI NVS)
BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
191MB LOWMEM available.
On node 0 totalpages: 49131
zone(0): 4096 pages.
zone(1): 45035 pages.
zone(2): 0 pages.
Kernel command line: BOOT_IMAGE=host19 ro root=301
BOOT_FILE=/boot/vmlinuz-2.4.1
9 console=ttyS0,9600 console=ttyS0,9600
Initializing CPU#0
Detected 706.972 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 1412.30 BogoMIPS
Memory: 192408k/196524k available (1069k kernel code, 3728k reserved, 260k
data,
60k init, 0k highmem)
Dentry cache hash table entries: 32768 (order: 6, 262144 bytes)
Inode cache hash table entries: 16384 (order: 5, 131072 bytes)
Mount-cache hash table entries: 4096 (order: 3, 32768 bytes)
Buffer-cache hash table entries: 8192 (order: 3, 32768 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 256K
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: Intel Pentium III (Coppermine) stepping 03
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
PCI: PCI BIOS revision 2.10 entry at 0xf0d90, last bus=2
PCI: Using configuration type 1
PCI: Probing PCI hardware
Unknown bridge resource 0: assuming transparent
PCI: Using IRQ router PIIX [8086/2440] at 00:1f.0
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ
SERIAL_PCI en
abled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
Real Time Clock Driver v1.10e
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ICH2: IDE controller on PCI bus 00 dev f9
ICH2: chipset revision 1
ICH2: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xb800-0xb807, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xb808-0xb80f, BIOS settings: hdc:pio, hdd:pio
hda: ST380020ACE, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: task_no_data_intr: status=0x51 { DriveReady SeekComplete Error }
hda: task_no_data_intr: error=0x04 { DriveStatusError }
hda: setmax_ext LBA 1, native 0
hda: 0 sectors (0 MB) w/2048KiB Cache, CHS=0/255/63, UDMA(33)
PPP generic driver version 2.4.2
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
IP: routing cache hash table of 1024 buckets, 8Kbytes
TCP: Hash tables configured (established 16384 bind 16384)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
hda1: bad access: block=2, count=2
end_request: I/O error, dev 03:01 (hda), sector 2
EXT2-fs: unable to read superblock
hda1: bad access: block=0, count=1
end_request: I/O error, dev 03:01 (hda), sector 0
FAT: unable to read boot sector
hda1: bad access: block=128, count=1
end_request: I/O error, dev 03:01 (hda), sector 128
read_super_block: bread failed (dev 03:01, block 128, size 512)
hda1: bad access: block=16, count=1
end_request: I/O error, dev 03:01 (hda), sector 16
read_super_block: bread failed (dev 03:01, block 16, size 512)
Kernel panic: VFS: Unable to mount root fs on 03:01
--
In case of 2.4.18 kernel, the booting message as follows...
Linux version 2.4.18 (root@i076) (gcc version 2.95.4 (Debian prerelease)) #5
Fri Mar 22 19:21:49 KST 2002
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 000000000bfeb000 (usable)
BIOS-e820: 000000000bfeb000 - 000000000bfef000 (ACPI data)
BIOS-e820: 000000000bfef000 - 000000000bfff000 (reserved)
BIOS-e820: 000000000bfff000 - 000000000c000000 (ACPI NVS)
BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
On node 0 totalpages: 49131
zone(0): 4096 pages.
zone(1): 45035 pages.
zone(2): 0 pages.
Local APIC disabled by BIOS -- reenabling.
Found and enabled local APIC!
Kernel command line: BOOT_IMAGE=host18 ro root=301
BOOT_FILE=/boot/vmlinuz-2.4.18
Initializing CPU#0
Detected 706.973 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 1412.30 BogoMIPS
Memory: 191400k/196524k available (1064k kernel code, 4736k reserved, 287k
data, 76k init, 0k highmem)
Dentry-cache hash table entries: 32768 (order: 6, 262144 bytes)
Inode-cache hash table entries: 16384 (order: 5, 131072 bytes)
Mount-cache hash table entries: 4096 (order: 3, 32768 bytes)
Buffer-cache hash table entries: 8192 (order: 3, 32768 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
CPU: Before vendor init, caps: 0383fbff 00000000 00000000, vendor = 0
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 256K
CPU: After vendor init, caps: 0383fbff 00000000 00000000 00000000
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: After generic, caps: 0383fbff 00000000 00000000 00000000
CPU: Common caps: 0383fbff 00000000 00000000 00000000
CPU: Intel Pentium III (Coppermine) stepping 03
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
enabled ExtINT on CPU#0
ESR value before enabling vector: 00000000
ESR value after enabling vector: 00000000
Using local APIC timer interrupts.
calibrating APIC timer ...
..... CPU clock speed is 706.9670 MHz.
..... host bus clock speed is 100.9952 MHz.
cpu: 0, clocks: 1009952, slice: 504976
CPU0<T0:1009952,T1:504976,D:0,S:504976,C:1009952>
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: Intel
PCI: PCI BIOS revision 2.10 entry at 0xf0d90, last bus=2
PCI: Using configuration type 1
PCI: Probing PCI hardware
Unknown bridge resource 0: assuming transparent
PCI: Using IRQ router PIIX [8086/2440] at 00:1f.0
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ
SERIAL_PCI enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
request_module[parport_lowlevel]: Root fs not mounted
lp: driver loaded but no devices found
ppdev: user-space parallel port driver
block: 128 slots per queue, batch=32
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev f9
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xb800-0xb807, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xb808-0xb80f, BIOS settings: hdc:pio, hdd:pio
hda: ST380020ACE, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: 156301488 sectors (80026 MB) w/2048KiB Cache, CHS=9729/255/63, UDMA(33)
Partition check:
hda: hda1
PPP generic driver version 2.4.1
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
IP: routing cache hash table of 1024 buckets, 8Kbytes
TCP: Hash tables configured (established 16384 bind 16384)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
FAT: bogus logical sector size 0
reiserfs: checking transaction log (device 03:01) ...
Using r5 hash to sort names
ReiserFS version 3.6.25
VFS: Mounted root (reiserfs filesystem) readonly.
Freeing unused kernel memory: 76k freed
8139too Fast Ethernet driver 0.9.24
PCI: Found IRQ 10 for device 02:0e.0
eth0: RealTek RTL8139 Fast Ethernet at 0xcc8b5000, 00:50:fc:3b:2a:76, IRQ 10
eth0: Identified 8139 chip type 'RTL-8139C'
eth0: Setting half-duplex based on auto-negotiated partner ability 0000.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/