00:1f.1 IDE interface: Intel Corp. 82801CAM IDE U100 (rev 02) (prog-if
8a [Master SecP PriP])
Subsystem: Toshiba America Info Systems: Unknown device 0001
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 0
Interrupt: pin A routed to IRQ 11
Region 0: I/O ports at cff8 [size=8]
Region 1: I/O ports at cff4 [size=4]
Region 2: I/O ports at cfe8 [size=8]
Region 3: I/O ports at cfe4 [size=4]
The hardware isnt at the normal ide base addresse, yet the chip is
reporting that it isnt in native mode. As far as I can see this
configuration isnt allowed.
We see that the chip isnt in native mode so we defer to the legacy
scanner. Since the ports are not valid the legacy scanner doesn't find
them.
Any thoughts on how we should handle this case Andre ?
Alan
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/