> Stephan von Krawczynski wrote:
> > I found out within minutes that this setup does not survive if you let the
> > Broadcom cards share interrupts with anything else. It works ok now like
> > this (eth2 is tg3):
> > But horribly failed in such a setup:
> > I cannot even produce a "cat /proc/interrupts" for this because I am not
> > fast enough at login (the network at eth2 is heavy loaded). I sometimes
> > read about problems here with tg3-drivers, and I just wanted to point you
> > to the shared case, maybe it has to do with this special case rather than
> > with the drivers internals itself.
> > (PS: its not the ide2-3, I checked that out)
> hmmm. I've attached the latest tg3, version 1.4, which I just sent off
> to Marcelo. It includes some fixes that may affect your 5701.
> Can you try two things?
> 1) 2.4.21-pre4 + tg3 v1.4
Ok. With the latest version you sent I got it compiled and working. As far as I
can tell from short tests it looks good (eth2 is tg3):
0: 79344 XT-PIC timer
1: 2428 XT-PIC keyboard
2: 0 XT-PIC cascade
5: 0 XT-PIC EMU10K1
7: 81 XT-PIC HiSax
9: 387286 XT-PIC aic7xxx, aic7xxx, eth0, eth1, eth2
11: 75780 XT-PIC ide2, ide3
12: 17740 XT-PIC PS/2 Mouse
15: 2 XT-PIC ide1
To make sure I will let it stress-test overnight and send you the results in
about 15 hours from now on. If everything does fine I will redo with ide2,ide3
on same interrupt, too. Just to see what happens with these Promise things...
-- Thanks a lot, I'll be back, Stephan - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to email@example.com More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/