> >>> "Richard B. Johnson" firstname.lastname@example.org> 02/03/03 03:12PM >>
> Thanks for the quick response, Richard!
> > Perhaps dmesg will explain better:
> > eth0: AMD79C901 HomePNA PHY transceiver found at address 2.
> > eth0: AMD79C901 10BASE-T PHY transceiver found at address 3.
> > eth0: using transceiver found at address 2 as default
> > eth0: SiS 900 PCI Fast Ethernet at 0xec400, IRQ 11,
> >This looks as though your wire is just connected backwards, i.e.,
> >you have a reversed patch-cord.
> The patch cable I've got has worked on other machines and hub set up
> for 10Base-T.
> >Are you connected to a Hub? Does the LED on the hub show that
> >the wire is connected properly an does the LED on/near the connector
> >your PC show that its connected correctly also?
> Both the hub and the PC show link lights when connected, yes. The hub
> is 10Base-T also.
Hmmm. That shows that whatever is connected is connected okay.
> >If you really do have to such connectors, just use eth1 instead of
> >eth0, i.e., `ifconfig eth1 ip-address ...`
> I will certainly give this a try. It's turning out to be quite an
> experience in how the Linux kernel thinks of devices. :) I don't really
> care which eth port it uses, as long as it works.
> So my ifconfig would be:
> ifconfig eth1 address 192.168.0.4 netmask 255.255.255.0
> - right?
That's what I'd try --for a start.
> I'm curious though - does ipconfig actually *create* the device ethx?
> Isn't that what the SIS900 module is doing -- detecting a device and
> mapping it onto eth0? dmesg does not reveal a similar report for eth1.
> In that case, how do I force it to use the transceiver at address 3 (see
> the dmesg above), or will it decide to use that one automatically? Sorry
> for my ignorance.
Well most all the devices are virtual. Some ethernet drivers handle
multiple configurations as multiple devices, others do not. I'm
just guessing since I do not use the SIS900 module here.
What I see from the source is that the HomePNA is set because
the board reported a certain identification, 0x6b90. Now, that
doesn't mean too much because a further reading of the source shows....
"If no one link is on, select PHY whose types is HOME as default." sic
So, I would guess, that MAYBE you booted your machine without the
cable connected to your hub and that's why it defaulted to HomePNA?
Anyway, `rmmod sis900;ifconfig eth0 192.168.0.4 etc...` to remove and
reinstall to see if that fixes it...
Penguin : Linux version 2.4.18 on an i686 machine (797.90 BogoMips).
Why is the government concerned about the lunatic fringe? Think about it.
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to email@example.com
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/