Re: AMD MP, SMP, Tyan 2466

Timothy Miller (miller@techsource.com)
Wed, 25 Jun 2003 18:59:05 -0400


Edward Tandi wrote:

>
>
> Yes, for SMP mode you absolutely need to use 'registered' RAM. Normal
> PC2100 ram will work OK with one processor but quickly fails with two (I
> had the same problems). Apparently, DDR RAM uses one clock edge to
> transfer in one direction and the opposite edge to transfer back again
> so the registers do synchronisation between one processor writing to the
> same location that the other one reads from. That's how it was explained
> to me anyway.
>

DDR memory works very much like single data rate, except that data is
transferred (in whichever direction it's going) on both edges of the
clock, thus doubling the transfer rate. The memory does not switch
between reading and writing as you describe it.

I believe registering is for reliability. Data is transferred one clock
cycle later but reduces signal loading.

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/