Re: IDE error msg w/2.2.10+idepatch,SiS5571,ALi15x3

[Massoud Asgharifard]

ALi15x3 is rev.193 (/proc/pci follows)
(I repeat: the error message does not always appear. I saw it once,
during a performance test with hdparm-3.5, with UDMA mode 2)
----

PCI devices found:
  Bus  0, device   0, function  0:
    Host bridge: Acer Labs M1541 Aladdin V (rev 4).
      Slow devsel.  Master Capable.  Latency=64.  
      Non-prefetchable 32 bit memory at 0xe0000000 [0xe0000000].
  Bus  0, device   1, function  0:
    PCI bridge: Acer Labs M5243 AGP (rev 4).
      Slow devsel.  Master Capable.  Latency=64.  Min Gnt=3.
  Bus  0, device   2, function  0:
    USB Controller: Acer Labs M5237 USB (rev 3).
      Medium devsel.  Fast back-to-back capable.  IRQ 11.  Master Capable.  Latency=64.  Max Lat=80.
      Non-prefetchable 32 bit memory at 0xdffff000 [0xdffff000].
  Bus  0, device   3, function  0:
    Bridge: Acer Labs M7101 PMU (rev 0).
      Medium devsel.  Fast back-to-back capable.  
  Bus  0, device   7, function  0:
    ISA bridge: Acer Labs M1533 Aladdin IV (rev 195).
      Medium devsel.  Master Capable.  No bursts.  
  Bus  0, device   8, function  0:
    Ethernet controller: DEC DC21140 (rev 18).
      Medium devsel.  Fast back-to-back capable.  IRQ 10.  Master Capable.  Latency=64.  
      I/O at 0xdc80 [0xdc81].
      Non-prefetchable 32 bit memory at 0xdfffef80 [0xdfffef80].
  Bus  0, device  15, function  0:
    IDE interface: Acer Labs M5229 TXpro (rev 193). <<<<<<<<< NOTE THIS :)
      Medium devsel.  Fast back-to-back capable.  Master Capable.  Latency=32.  Min Gnt=2.Max Lat=4.
      I/O at 0xffa0 [0xffa1].
-----

--masu

-
This message is Ozone-Friendly.
-

On Mon, 23 Aug 1999 [e-mail] wrote:

> 
> SiS5571 chipset core is not supported to date.
> As for the Ali15x3, if the M5229 is not of 0xC1 or rev. 193 or newer,
> there is no support designed to date.  The docs are rough in the decoding
> process.
> 
> Andre Hedrick
> The Linux IDE guy
> 
> On Mon, 23 Aug 1999, Massoud Asgharifard wrote:
> 
> > hi all, 
> > 
> > I sometimes get this message from 2.2.10 kernel:
> > 
> > hda: drive_cmd: status=0x51 { DriveReady SeekComplete Error }
> > hda: drive_cmd: error=0x04 { DriveStatusError }
> > 
> > The kernel is patched with 2.2.10 ide patch from kernel.org 
> > controllers are SiS-5571(Asus SP97V) and ALi15x3 (GigaByte 5AA). I enabled
> > UDMA on them with 'hdparm -d 1 /dev/hda'. When I tried 'hdparm -tT
> > /dev/hda' I got the above error. 
> > harddisks are 
> > 'hda: QUANTUM FIREBALL SE2.1A, 2014MB w/80kB Cache, CHS=1023/64/63,
> > UDMA(33)' according to boot messages.
> > I don't always get the message...just sometime.
> > Any ideas?
> > 
> > --masu

--masu

-
This message is Ozone-Friendly.
-