Re: eepro100 not working properly

Jeff Garzik (jgarzik@mandrakesoft.com)
Mon, 14 Feb 2000 01:23:06 -0500

Jens Axboe wrote:
> eepro100 does not work well after the 2.3.45 changes. It works after
> a cold boot, but after a warm reboot no go. The device is detected
> and eth0 brought up, but I get no response from the other end.

Can you check and see if this behavior exists in 2.3.45-pre2 also?

I enabled Becker's ACPI logic in 2.3.45 eepro100, and that sounds like
it may be the culprit.

-- 
Jeff Garzik         | Writing software is
Building 1024       | more fun than working.
MandrakeSoft, Inc.  | 	-Anon


-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/