Re: eepro100 not working properly

Jens Axboe (axboe@suse.de)
Mon, 14 Feb 2000 07:45:09 -0500

On Mon, Feb 14 2000, Jeff Garzik wrote:
> > eepro100 does not work well after the 2.3.45 changes. It works after
> > a cold boot, but after a warm reboot no go. The device is detected
> > and eth0 brought up, but I get no response from the other end.
>
> Can you check and see if this behavior exists in 2.3.45-pre2 also?

Ok, I got and compiled 2.3.45-pre2. It has similar problems --
does not work when the machine is rebooted. 2.3.44 is fine.

> I enabled Becker's ACPI logic in 2.3.45 eepro100, and that sounds like
> it may be the culprit.

Other ideas?

-- 
*  Jens Axboe <axboe@suse.de>
*  Linux CD-ROM Maintainer
*  http://www.kernel.dk


-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/