Re: PCMCIA still doesn't work for 2.3.46-pre2

[Richard Gooch]

Daniel Egger writes:
> On 16 Feb, Richard Gooch wrote:
> 
> > Linux PCMCIA Card Services 3.1.11
> >   options:  [pci] [cardbus] [apm]
> > Adding cardbus controller 0: PCI device 104c:ac15
> > PCI: Enabling device 00:04.0 (0000 -> 0002)
> > Yenta IRQ list 0000, PCI irq0
> > Socket status: 30000059
> > Adding cardbus controller 1: PCI device 104c:ac15
> > PCI: Enabling device 00:04.1 (0000 -> 0002)
> > Yenta IRQ list 0000, PCI irq0
> > [...]
> > cs: IO port probe 0x038c-0x03ff: excluding 0x3c4-0x3e3 0x3ec-0x403
> > cs: IO port probe 0x0230-0x0387: excluding 0x378-0x37f
> > cs: IO port probe 0x0100-0x021f: clean.
> > cs: memory probe 0xa0000000-0xa0ffffff: clean.
> > xirc2ps_cs.c 1.31 1998/12/09 19:32:55 (dd9jn+kvh)
> > xirc2ps_cs: RequestIRQ: Resource in use
>  
> > Bugger.
> 
>  I normally get the same output but sometimes it just works...
>  strange...

Well, at the moment I'm using my other network card with 2.3.46-pre2
and it's working:

Linux PCMCIA Card Services 3.1.11
  options:  [pci] [cardbus] [apm]
Adding cardbus controller 0: PCI device 104c:ac15
PCI: Enabling device 00:04.0 (0000 -> 0002)
Yenta IRQ list 0e98, PCI irq0
Socket status: 30000010
Adding cardbus controller 1: PCI device 104c:ac15
PCI: Enabling device 00:04.1 (0000 -> 0002)
Yenta IRQ list 0e88, PCI irq0
Socket status: 30000006
[...]
cs: IO port probe 0x038c-0x03ff: excluding 0x3c4-0x3e3 0x3ec-0x403
cs: IO port probe 0x0230-0x0387: excluding 0x378-0x37f
cs: IO port probe 0x0100-0x021f: clean.
cs: memory probe 0xa0000000-0xa0ffffff: clean.
eth0: NE2000 Compatible: io 0x300, irq 3, hw_addr 00:40:33:9A:22:26

The difference seems to be that this card is 16 bit, whereas the other
card is (it had better be!) 32 bit.

				Regards,

					Richard....
Permanent: [e-mail]
Current:   [e-mail]