Re: [preview] VIA IDE 4.0 and AMD IDE 2.0 with automatic PCI clock detection

[Vojtech Pavlik]

On Fri, Feb 09, 2001 at 04:42:52PM -0600, Philip Langdale wrote:
>  	
> Content-Type: text/plain; charset=us-ascii
> Content-Transfer-Encoding: 7bit
> 
> Vojtech,
> 
> I've tried out your new via driver and it
> appears to have solved the problem with
> the mis-detected ls-120 drive, but the ata66
> drives are still being run at 33. 
> 
> More interestingly, the pci-clk calculations
> seem to be returning badly off values.
> 
> My motherboard is a kt133a+686b btk7a from abit.
> 
> When I set the FSB to 133 with PCI=133/4=33 the
> timing code returns 43mhz.
> 
> when I set the FSB to 100 with PCI=100/3=33 then
> it returns 42mhz.
> 
> These are scarely different from the nominal values.
> I didn't observe anything bad in the few minutes
> I was running like this, but right now I've hacked
> the driver back to a hardcoded 33.
> 
> What should I do next?

Are you willing to do some experiments? I suppose the 686b is somewhat
different than the other chips (I tested it on 686a and 586b).

-- 
Vojtech Pavlik
SuSE Labs