Re: opl3sa2 in 2.4.2 on Toshiba Tecra 8000

[Bill Nottingham]

Klaus Reimer ([e-mail]) said: 
> If I am doing this, I can't even load the module and I get the following 
> message in syslog:
> 
> 2001-03-29 18:13:14.184156500 {kern|err} kernel: opl3sa2: Control I/O port 
> 0x0 not free
> 
> What is that "control i/o port"? Is this normally 0x100?

I believe it can be, but I remember it usually being something
like 0x370 or so.

> What is the module 
> parameter to specify this io port? The documentation only mentions "io", 
> "mpu_io" and "mss_io" but I have specified these parameters already:
> 
> modprobe opl3sa2 io=0x538 mss_io=0x530 mpu_io=0x330 irq=5 dma=1 dma2=0 
> isapnp=0

It would be what you put in the io= parameter. 0x538 does *not* look
right.

Bill