Re: ATA 100

[Nicholas Petreley]

I have the same motherboard, and it works fine for me.  Note the 
80w cable detection.  Perhaps you've got a bad cable?

-Nick

----------VIA BusMastering IDE Configuration----------------
Driver Version:                     3.23
South Bridge:                       VIA vt82c686b
Revision:                           ISA 0x40 IDE 0x6
Highest DMA rate:                   UDMA100
BM-DMA base:                        0xd800
PCI clock:                          33MHz
Master Read  Cycle IRDY:            0ws
Master Write Cycle IRDY:            0ws
BM IDE Status Register Read Retry:  yes
Max DRDY Pulse Width:               No limit
-----------------------Primary IDE-------Secondary IDE------
Read DMA FIFO flush:          yes                 yes
End Sector FIFO flush:         no                  no
Prefetch Buffer:              yes                  no
Post Write Buffer:            yes                  no
Enabled:                      yes                 yes
Simplex only:                  no                  no
Cable Type:                   80w                 80w
-------------------drive0----drive1----drive2----drive3-----
Transfer Mode:       UDMA      UDMA      UDMA       PIO
Address Setup:       30ns      30ns      30ns     120ns
Cmd Active:          90ns      90ns      90ns      90ns
Cmd Recovery:        30ns      30ns      30ns      30ns
Data Active:         90ns      90ns      90ns     330ns
Data Recovery:       30ns      30ns      30ns     270ns
Cycle Time:          20ns      20ns      60ns     600ns
Transfer Rate:  100.0MB/s 100.0MB/s  33.3MB/s   3.3MB/s