2.4.9: PDC20267 not working

Joe Fago (cfago@tconl.com)
Sun, 09 Sep 2001 20:26:08 -0500


Hi,

System hangs on boot:

Uniform Multi-Platform E_IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with
idebus=xx
PDC20267: IDE controller on PCI bus 00 dev 40
PCI: Assigned IRQ 10 for device 00:08.0
PDC20267: chipset revision 2
PDC20267: not 100% native mode: will probe irqs later
PDC20267: (U)DMA Burst Bit ENABLED Primary PCI Mode Secondary PCI Mode
ide0: BM-DMA at 0xe800-0xe807, BIOS settings: hda: pio, hdb: pio
ide1: BM-DMA at 0xe808-0xe80f, BIOS settings: hdc: pio, hdd: DMA
hda: Maxtor 2B020H1, ATA DISK drive

This is the only device attached to the controller. Any suggestions?

Thanks,
Joe

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/