(scsi0:A:4): 10.000MB/s transfers (10.000MHz, offset 15)
Vendor: OLYMPUS Model: MOS364 Rev: 1.02
Type: Optical Device ANSI SCSI revision: 02
(scsi0:A:5): 10.000MB/s transfers (10.000MHz, offset 15)
Vendor: OLYMPUS Model: MOS364 Rev: 1.02
Type: Optical Device ANSI SCSI revision: 02
[----------snip----------]
Attached scsi removable disk sda at scsi0, channel 0, id 4, lun 0
Attached scsi removable disk sdb at scsi0, channel 0, id 5, lun 0
SCSI device sda: 310352 2048-byte hdwr sectors (636 MB)
sda: Write Protect is off
sda:<5>ll_rw_block: device 08:00: only 2048-char blocks implemented (1024)
unable to read boot sectors / partition sectors
SCSI device sdb: 310352 2048-byte hdwr sectors (636 MB)
sdb: Write Protect is off
sdb:<5>ll_rw_block: device 08:10: only 2048-char blocks implemented (1024)
unable to read boot sectors / partition sectors
[----------snip----------]
$ cat /proc/partitions
major minor #blocks name
8 0 620704 sda
8 16 620704 sdb
8 0 620704 sda
8 16 620704 sdb
8 0 620704 sda
8 16 620704 sdb
8 0 620704 sda
8 16 620704 sdb
8 0 620704 sda
8 16 620704 sdb
8 0 620704 sda
8 16 620704 sdb
8 0 620704 sda
8 16 620704 sdb
<continues forever>
In this case, there is no partition table on the magneto optical media
(since there seems little reason for such things)
$ fdisk -l /dev/sda
Note: sector size is 2048 (not 512)
Disk /dev/sda: 64 heads, 32 sectors, 151 cylinders
Units = cylinders of 2048 * 2048 bytes
Disk /dev/sda doesn't contain a valid partition table
$
$ file -s /dev/sda
/dev/sda: Linux rev 1.0 ext2 filesystem data
-Erik
-- Erik B. Andersen email: andersee@debian.org, formerly of Lineo --This message was written using 73% post-consumer electrons-- - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/