Re: 3c59x:command 0x3002 did not complete! Status=0xffff

[Harald Dunkel]

Hi Andrew,

Andrew Morton wrote:
> 
> Harald Dunkel wrote:
> >
> > Hi folks,
> >
> > Does anybody know what this message in kern.log means?
> >
> >         eth0: command 0x3002 did not complete! Status=0xffff
> >
> 
> There's a function in the driver which issues reset commands to the
> hardware and then spins, waiting for completion.  Usually it takes
> a single PCI cycle.  In your case it timed out.
> 
> It look to me like the NIC is powered down.  Could you please
> send me a bunch of info:
> 
> - Does the interface actually work after this message, or is
>   it dead?
> 

A ping to the assigned IP address works. But I cannot get a PPPoE
connection.

> - If the latter, did you warmboot from another OS?
> 
I've got just Linux. The problem occurs after a warm boot as
it seems. When I do a power-down reset, then I don't get this
message, but I don't get a connection via PPPoE, either.

> - Does it help if you add the line
> 
>         options 3c59x enable_wol=1
> 
>   to /etc/modules.conf?  (This is a misnomer - enable_wol
>   enables the driver's power management functions).
> 

No, this did not help. I found an old EMail with the suggestion 
to add enable_wol=0, but this didn't help, either.

The problem came up this morning (12 hours ago). Before the it was 
working, AFAICT.

Regards

Harri