Re: aic7xxx driver v6.2.4 "queue abort message" questions

Richard Harman (rharman@xabean.net)
Wed, 16 Jan 2002 11:01:11 -0500


It's a dual P3 600/100 with 512mb of ram, tyan thunder 100 gx (s1836dulan model) with an onboard aic-7895 dual channel UW SCSI. I'm booting off channel B (the 68pin only channel) Id 1, which is my seagate 36g SCA drive in a 5 bay sca enclosure. Id 0 is a ultraplex 40x. Channel A has a 50pin 8x2x20 plexwriter. The motherboard has a PIIX4 (GX) chipset. (http://www.tyan.com/products/html/a_thunder100gx.html)

I've hand copied down what I could of the v6.2.4 driver's debug messages, but wasn't able to catch all of it. (I hope to switch to serial console as soon as I find a null modem cable and log it that way.) Shall I send the screenfull to the list or you directly?

Thanks,
Richard G Harman Jr <rharman+nospam@xabean.net>

Quoted from "Justin T. Gibbs":
> >I've got a box that will nolonger boot off it's scsi disk anymore, (but dual b
> >ooting to windows works just fine...) did anyone ever get to the bottom of wha
> >t caused the "attempting to queue an abort message" bug was?
>
> Those messages don't usually indicate bugs. Without knowing more about
> your system, the devices attached to it, if you happen to have one of
> those broken VIA chipsets, etc. its hard to diagnose your problem.
>
> --
> Justin
>
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/