Re: [bug] 2.4.19-pre4-ac2 hang at boot with ALI15x3 chipset support

[James Mayer]

> James> hda: status error: status=0x58 { DriveReady SeekComplete DataRequest }
> James> hda: drive not ready for command
> 
> I ran into this as well under various kernels including 2.4.18.  Try
> adding:
>     append="idebus=50"
> 
> to the lilo stanza for your kernel.
> 
> It seems even after I amputated the offending "write" that causes the
> lockup, the bus speed was being set to 33MHz instead of 50Mhz.  The
> above solved the problem for me.

This worked for me as well -- interesting.

> For anyone else trying to configure the pcg-c1mrx or pcg-c1mv, I'm
> updating linux configuration document as I work through the
> setup of the various devices:
>     http://hale.org/~bhoward/issue_7/pcg-c1mrx.html

Good information there.  Oddly enough, I don't need to specify the
pci=conf2, though.

Thanks to everyone for the speedy assistance!
 - James