Re: PPC and 2.2.21rc3 with modular ide subsystem

[Krzysiek Taraszka]

On Fri, 3 May 2002, Tom Rini wrote:

> Date: Fri, 3 May 2002 09:43:58 -0700
> From: Tom Rini <[e-mail]>
> To: Krzysiek Taraszka <[e-mail]>
> Cc: [e-mail]
> Subject: Re: PPC and 2.2.21rc3 with modular ide subsystem
> 
> On Fri, May 03, 2002 at 06:05:34PM +0200, Krzysiek Taraszka wrote:
> > On Fri, 3 May 2002, Tom Rini wrote:
> > 
> > > Date: Fri, 3 May 2002 08:53:13 -0700
> > > From: Tom Rini <[e-mail]>
> > > To: Krzysiek Taraszka <[e-mail]>
> > > Cc: [e-mail]
> > > Subject: Re: PPC and 2.2.21rc3 with modular ide subsystem
> > > 
> > > On Fri, May 03, 2002 at 01:58:49PM +0200, Krzysiek Taraszka wrote:
> > > 
> > > > I tried compile 2.2.21rc3 with modular ide subsystem and i got that 
> > > > messages:
> > > 
> > > Pmac IDE is not able to be built as a module.  If you just have a PCI
> > > IDE card you want to use, you should be able to if you set
> > > CONFIG_BLK_DEV_IDE_PMAC to n.  Otherwise you must compile it in.
> > 
> > What about 2.4/2.5 kernels ? 
> 
> The same restrictions apply to 2.4 as well.  It's planned to try and fix
> this issue in 2.5 at some point.

Thank you very much.

Krzysiek Taraszka			([e-mail])