Re: No Subject

[Henning P. Schmiedehausen]

Bartlomiej Zolnierkiewicz <[e-mail]> writes:

>On 4 Aug 2002, Alan Cox wrote:

>> On Sat, 2002-08-03 at 23:16, Bartlomiej Zolnierkiewicz wrote:
>> > Just rethough it. What if chipset is in compatibility mode?
>> > Like VIA with base addresses set to 0?
>>
>> If we found a register that was marked as unassigned with a size then we
>> would map it to a PCI address. That would go for BAR0-3 on any PCI IDE
>> device attached to the south bridge.
>>
>> What problems does that cause for the VIA stuff ?

>In compatibility mode IDE chipsets have IO at legacy ISA ports and
>PCI_BASE_ADDRESS0-3 are set to them or to zero (at least on VIA).
>And they can't be programmed to any other ports (unless native mode).

Hi,

this sounds like a problem that I have with the ServerWorks OSB5
chipset. I actually have PCI_BASE_ADDRESS0-3 at 0 and
PCI_BASE_ADDRESS4 = 0x3a0.

Does this hold true here, too? Or is this VIA specific?

	Regards
		Henning

-- 
Dipl.-Inf. (Univ.) Henning P. Schmiedehausen       -- Geschaeftsfuehrer
INTERMETA - Gesellschaft fuer Mehrwertdienste mbH     [e-mail]

Am Schwabachgrund 22  Fon.: 09131 / 50654-0   [e-mail]
D-91054 Buckenhof     Fax.: 09131 / 50654-20