Hi All,
Sorry for disturbing the list again.
I am using RTL8139C in our target board which is based on MIPS
IDT32334 processor.
The version of 8139too.c that i am using is 1.0.1 where as I am
using a embedded linux which is based on Linux Kernel
2.4.5-pre1.
When the packet is transmitted out, it is coming out as all
0's(captured using sniffer). I dumped the whole packet in
rtl8139_start_xmit (). The packet is a valid ARP packet.
My doubt is whether this 8139too.c is tested with MIPS
processors?
Because in one of the article i found that the supported
processors are ARM, i386 etc.
Can any body throw some light on this?
with best regards,
Nanda
\
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/