Re: Linux 2.4.20-pre4-ac1

[Tomas Szepe]

> > > "Warning: Limiting speed since you did not use an 80-conductor cable"
> > 
> > Pronouns should generally be avoided in formulations such as this one,
> > simply because there's no way to tell who it really was who didn't use
> > an 80-conductor cable. Go with a passive sentence instead.
> 
> "Warning: The speed was limited because the 80-conductor cable wasn't used 
> (and got annoyed for that reason)."?
> "Warning: 80-conductor cable wasn't, so it must have been the speed 
> which got used to reducing itself."

ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: IDE controller on PCI bus 00 dev 39
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: VIA vt82c686b (rev 40) IDE UDMA100 controller on pci00:07.1
    ide0: BM-DMA at 0xd000-0xd007, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0xd008-0xd00f, BIOS settings: hdc:DMA, hdd:DMA
hda: ST380021A, ATA DISK drive
hdc: PLEXTOR CD-R PX-W2410A, ATAPI CD/DVD-ROM drive
hdd: CD-532E-B, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
ide0:
    It appears an 80-conductor cable is not in use.
    => Transfer rates above UDMA2 won't work.
ide1:
    It appears an 80-conductor cable is not in use.
    => Transfer rates above UDMA2 won't work.
...