RE: Linux hot swap support

Bloch, Jack (Jack.Bloch@icn.siemens.com)
Wed, 18 Sep 2002 17:51:30 -0400


Thanks for the help, but a generic question. If my HW has a hotswap
controller (theoretically), I do not need any thrird party SW to handle the
hot swap insert/remove. Linux 2.4.18-3 Kernel should support this correct? I
should just run /sbin/hotplug pci on start up.

Jack Bloch
Siemens ICN
phone (561) 923-6550
e-mail jack.bloch@icn.siemens.com

-----Original Message-----
From: Greg KH [mailto:greg@kroah.com]
Sent: Wednesday, September 18, 2002 5:48 PM
To: Bloch, Jack
Cc: linux-kernel@vger.kernel.org
Subject: Re: Linux hot swap support

On Wed, Sep 18, 2002 at 05:37:50PM -0400, Bloch, Jack wrote:
> At the moment, I only support removal. The way it works is as follows.
>
> Upon system start up my device driver detects all of the boards which are
> present (I support up to six). For each board it allocates the necessary
I/O
> lists memory needed for operation. All addresses are then mapped to user
> space with a mmap interface. Now, all HW is accessible from user space.
For
> each device, an ISR is installed. As soon as the ejector handle for a
> particular device is opened, the board (which is a Motorola 68060 based
> board) issues an interrupt to me. I will shut this board down and
> de-allocate any of the previously reserved resources. What is not so easy
is
> to perform the insert. I thought about allocating memory becessary for a
> maximum configuration, but I would still need to get the insertion event.
> But anyway since our device (even though it has multiple boards
internally)
> is seen as a monolithic device from the main controlling host, the loss of
a
> single board causes it to be taken out of service.

Hm, you might want to take a look at the cPCI patches from Scott Murray,
he has a solution for the resource and insertion problem that will
probably work for you. You can find the patches on the pcihpd-discuss
mailing list, and I think they were also posted to lkml in the past too.
He's working on cleaning them up a bit for inclusion in the main kernel
tree.

Hope this helps,

greg k-h
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/