Re: [BENCHMARK] 2.4.{18,19{-ck9},20rc1{-aa1}} with contest
Jens Axboe (axboe@suse.de)
Sun, 10 Nov 2002 11:09:42 +0100
On Sun, Nov 10 2002, Con Kolivas wrote:
> >The default is 2048. How long does the io_load test take, or rather how
> >many tests are appropriate to do? To get a good picture of how it looks
> >you should probably try: 0, 8, 16, 64, 128, 512. Once you get some of
> >these results, it will be easier to determine which area(s) would be
> >most interesting to further explore.
> 
> The io_load test takes as long as the time in seconds shown on the table. At 
> least 3 tests are appropriate to get a reasonable average [runs is in square 
> parentheses]. Therefore it takes about half an hour per run. Luckily I had 
> the benefit of a night to set up a whole lot of runs:
> 
> io_load:
> Kernel [runs]           Time    CPU%    Loads   LCPU%   Ratio
> 2420rc1r0 [3]           489.3   15      36      10      6.85
> 2420rc1r8 [3]           485.5   15      35      10      6.80
> 2420rc1r16 [3]          570.4   12      43      10      7.99
> 2420rc1r32 [3]          570.1   12      42      10      7.98
> 2420rc1r64 [3]          575.0   12      43      10      8.05
> 2420rc1r128 [3]         611.4   11      46      10      8.56
> 2420rc1r256 [3]         646.2   11      49      10      9.05
> 2420rc1r512 [3]         603.7   12      45      10      8.46
> 2420rc1r1024 [3]        693.9   10      53      10      9.72
> 2.4.20-rc1 [2]          1142.2  6       90      10      16.00
> 
> Test hardware is 1133Mhz P3 laptop with 5400rpm ATA100 drive. I don't doubt 
> the response curve would be different for other hardware.
That looks pretty good, the behaviour in 2.4.20-rc1 is no sanely tunable
unlike before. Could you retest the whole contest suite with 512 as the
default value? It looks like a good default for 2.4.20.
Marcelo, we probably need to make few tweaks here to get the read
passover value right. The algorithmic changes in 2.4.20-pre made it
impossible to guess a good default value, as we invalidated the previous
tests. Right now we are using 2048 which is a number I basically pulled
out of my ass, it looks as if it might be a bit high. So I'll be sending
you a one-liner correction once a decent default value is found.
-- 
Jens Axboe
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/