Promise TX4 100: neither IDE port enabled

[Jonathan Vardy]

Hi,

I am having trouble getting my promise fasttrak TX4 running with Red
Hat. I am using kerner 2.4.21-pre6 compiled with 

PROMISE PDC202{46|62|65|67} support
Special UDMA Feature
PROMISE PDC202{68|69|70|71|75|76|77} support

But without Special FastTrak Feature and Support for IDE Raid
controllers (EXPERIMENTAL)

While booting I get the following results:

ide: Assuming 33MHz system bus speed for PIO modes; override with
idebus=xx
PIIX4: IDE controller at PCI slot 00:04.1
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xd800-0xd807, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0xd808-0xd80f, BIOS settings: hdc:pio, hdd:pio
PDC20270: IDE controller at PCI slot 02:01.0
PDC20270: chipset revision 2
PDC20270: not 100% native mode: will probe irqs later
PDC20270: neither IDE port enabled (BIOS)
PDC20270: neither IDE port enabled (BIOS)
hda: Maxtor 2B020H1, ATA DISK drive
blk: queue c0395860, I/O limit 4095Mb (mask 0xffffffff)
hdc: WDC WD1200BB-00CAA1, ATA DISK drive
blk: queue c0395cd0, I/O limit 4095Mb (mask 0xffffffff)
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: host protected area => 1
hda: 39062500 sectors (20000 MB) w/2048KiB Cache, CHS=2431/255/63,
UDMA(33)
hdc: host protected area => 1
hdc: 234441648 sectors (120034 MB) w/2048KiB Cache, CHS=232581/16/63,
UDMA(33)

As you can see the Promise card is not functioning at all. Doen anyone
have any ideas why it is not functioning?

Thanks, Jonathan Vardy