Re: my dual channel DDR 400 RAM won't work on any linux distro

John Bradford (john@grabjohn.com)
Wed, 16 Apr 2003 18:01:03 +0100 (BST)


> The board supports up to 4 GB total (4 DIMM slots), DDR 400/333/266. I'm
> normally using 2 * 512 MB DDR 400 on Single 128 bit mode. And the board's
> been tested to support up to 4 of the modules that I have (
> KVR400X64C25/512 ) shown at :
> http://www.giga-byte.com/MotherBoard/Support/TechnologyGuide/TechnologyGuide
> _63.htm
>
> motherboard link:
> http://www.giga-byte.com/MotherBoard/Products/Products_GA-SINXP1394(GA-8SQ80
> 0%20Ultra2).htm
>
> I tested both modules seperately just minutes ago, AND GET NO ERRORS on
> either one. The errors occur when I have both in.
>
> I've tried running them different speeds (e.g. 333), and it made no
> difference in what Linux did (black screened after kernel load).

Do you get errors with Memtest86, with both DIMMs installed, and set
to run at 333?

Also, try checking the power supply volatages are within spec.

John.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/