Re: Problems in kernel 2.4.70-mm9 with pcmcia xircom_cb

[jds]

  Hi:

    Thanks ....... again, my pcmcia card bus xircom_cb working good.

  Regards.

---------- Original Message -----------
From: Dominik Brodowski <[e-mail]>
To: [e-mail], [e-mail]
Sent: Fri, 13 Jun 2003 20:33:20 +0200
Subject: Re: Problems in kernel 2.4.70-mm9 with pcmcia xircom_cb

> Hi "jds",
> 
> Please run "oldconfig" on your .config, and select 
> 
> CONFIG_YENTA  CardBus yenta-compatible bridge support (NEW) "y"
> 
> (Or run any other config tool of your choice and adjust this setting).
> 
> If CONFIG_YENTA wasn't set before, this is likely the cause of the problem.
> If not, please contact me again.
> 
> 	Dominik
------- End of Original Message -------