Re: xircom card bus with 2.4.20 link trouble

[Mike Dresser]

On 20 Jun 2003, Arnaud Ligot wrote:

> Hello,
>
> Since I run the 2.4.20 kernel (+bootsplash patch), (I didn't try without
> this patch but I think it is not the problem), my Xircom Cardbus don't
> work any more! In fact, I put the card into the pcmcia slot, the pc
> detect it, load the correct module (xirc2ps_cb), start eth1 but the led
> link (both side) blinks.
> I have try with a hub 10, a ethernet card 10 and an ethernet card
> 10/100. I have so try 2 cables... but same problem.
> I have try to impose the ethernet type of link mii-tool -A10BaseT-HD and
> -F10BaseT-HD.
>
> Thanks
>
> Arnaud

Mine doesn't work either, I have a RBEM56G-100.

Bought this off ebay for quite cheap to replace my REM56G-100.

It detects it, etc etc, but never actually works.

I put the REM56G-100 back in, insmod'd the driver, and back in business.

I haven't tried a 2.5.x kernel, nor a 2.4.21(it's on my list of things to
do)

I was using the xircom_cb driver though.  The xircom_tulip_cb didn't work
either.

Mike