Re: aic7xxx and SiI3112 problems (2.4.21[-ac1] and 2.5.7x)

Justin T. Gibbs (gibbs@scsiguy.com)
Sat, 21 Jun 2003 16:14:03 -0600

> I have an Adaptec 29160N that uses the aic7xxx driver. I have had no
> problems with this driver in 2.4.20, but in 2.4.21, my drives fail parity
> checks. I've gone back and forward between 2.4.20 kernels and 2.4.21
> kernels just to make sure it wasn't the drive's fault. The exact error
> message(s) are at the middle-end of this email.

The typical reason that you might get a CRC error is that the termination
is not configured correctly on your card. I don't recall off hand any
particular termination issues for the 29160N that have been resolved
by driver releases after 6.2.8, but newer drivers do have more termination
diagnostics that may help me to resolve your problem. You should be able
to just drop in the latest driver from here:

http://people.FreeBSD.org/~gibbs/linux/SRC/

If the newer driver still causes problems, let me know and I can give
you instructions on how to enable the debugging I need to better understand
your problem.

--
Justin


-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/