2.6.0test 1 fails on eth0 up (arjanv RPM's - all needed rpms

Trever L. Adams (tadams-lists@myrealbox.com)
14 Jul 2003 14:56:26 -0400

OK, I now get past the initialization of the 3c920. However, now it
hangs (sak enabled, sak doesn't work... completely dead) when eth0 tries
to come up. I have IPv6 enabled (the router does 6to4, this isn't the
router), I don't believe I have any firewall stuff on this box, it does
dhcp for IPv4 address and ntp time.

There was an oops earlier in the boot process. It seems the sound card
(irq 3) did an irq and the kernel wasn't ready to accept so it barfed.
There may have been more to it than that, I will check later today. I
have to get back to my studies for now.

Trever

--
"My spelling is Wobbly. It's good spelling but it Wobbles, and the
letters get in the wrong places." -- A. A. Milne (1882-1958)


-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/