In my RH 6.0 scripts, changing to runlevel 3 is just
before: Bringing up interface lo.
My system's normal sequence is:
init: Entering runlevel: 3
network: Bringing up interface lo succeeded
netowrk: Bringing up interface eth0 succeeded
But in test6-preAny#, Bringing up interface lo just hangs.
~Randy
___________________________________________________
|Randy Dunlap Intel Corp., DAL Sr. SW Engr.|
|randy.dunlap.at.intel.com 503-696-2055|
|NOTE: Any views presented here are mine alone |
|and may not represent the views of my employer. |
|_________________________________________________|
> -----Original Message-----
> From: Chris Wedgwood [mailto:cw@f00f.org]
> Sent: Sunday, August 06, 2000 3:29 PM
> To: Dunlap, Randy
> Cc: Linus Torvalds; David S. Miller; Andrew Morton; Frank van
> Maarseveen; linux-kernel@vger.rutgers.edu
> Subject: Re: [andrewm@uow.edu.au: Re: 2.4.0-test6-pre5: fork: Resource
> tem porarily unavailable]
>
>
> I have the same result that Chris just reported. Still hanging
> during/after "Bringing up interface lo".
>
> That's _not_ what I see -- I see it after init tries to change
> runlevels; I suspect when there is only one process (or very few) the
> count get hosed on my system.
>
>
> --cw
>
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/