If replugging the cable helps, it has good chances to be not a driver bug.
It may happen to be hardware flow control misbehavior or something like it.
What is your mode (10/100 full/half duplex)?
There are a lot of things which may be done to get more information what
happens. Change cable. Try another port on hub. Try host-to-host
ethernet connection. Set speedo_debug to 3 in the driver. Check the card
status by mii-diag from scyld.com.
> Also the card is plugged into a Netgear 10/100 ds-108 8 port hub .
> But there are no logs of any failure of any subsystem . So I am
> at a loss as to even figure out where to go from here .
Best regards
Andrey V.
Savochkin
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/