Linux-kernel mailing list archive 2000-32,: Re: ncr53c400 SCSI card (HP scanner)

# Re: ncr53c400 SCSI card (HP scanner)

Davidovac Zoran (zdavid@unicef.org.yu)
Tue, 8 Aug 2000 11:19:55 +0200 (CEST)

- Messages sorted by: [ date ][ thread ][ subject ][ author ]
- Next message: David Woodhouse: "Re: Calling module functions from the kernel proper"
- Previous message: Andre Hedrick: "Re: Disable DMA"

Try 2.2.14 or 2.2.pre17 ....

2.2.16 has problems with scsi drivers ...

Regards,

Zoran

On Mon, 7 Aug 2000, Igmar Palsenberg wrote:

>
> Hi,
>
> Was playing to get this SCSI working, I discovered it is very good at
> hanging this system :-))
>
> Linux 2.2.16
> ncr53c400 (ncr8380) driver
>
> When specifying the IO adress and IRQ, the system gives :
>
> scsi0: SCSI bus busy, waiting up to 5 seconds
> scsi0: bus busy, attempting abort
>
> Then the system hangs. I can CTRL-ALT-DEL for an immediate reboot, but I
> didn't get the card working..
>
> Anyone any hints / way to debug this ?
>
>
>
> Regards,
>
>
> Igmar
>
>
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to majordomo@vger.rutgers.edu
> Please read the FAQ at http://www.tux.org/lkml/
>

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/

- Next message: David Woodhouse: "Re: Calling module functions from the kernel proper"
- Previous message: Andre Hedrick: "Re: Disable DMA"