[BUG/PATCH] : bug in tty_default_put_char()

[Jean Tourrilhes]

	Hi,

	Bug : tty_default_put_char() doesn't check the return value of
tty->driver.write(). However, the later may fail if buffers are full.

	Solution : It's not obvious what should be done. The attached
patch is certainly wrong, but gives you an idea of what the problem
is.

	Long story :
	User weant to do PPP over IrCOMM. "chat" opens ircomm device
in non blocking mode and write char by char. I suspect that it's using
the above call, but can't verify (because it doesn't happen to me). As
IrCOMM has not finished its initialisation (the open was
non-blocking), it refuses the write and returns 0.
	Character dropped, user unhappy, bugs me about it.
	I'll try to workaround that in IrCOMM.

	Regards,

	Jean

-----------------------------------------------
diff -u -p linux/drivers/char/tty_io.t1.c linux/drivers/char/tty_io.c
--- linux/drivers/char/tty_io.t1.c      Mon Aug 26 10:55:33 2002
+++ linux/drivers/char/tty_io.c Mon Aug 26 10:58:34 2002
@@ -2021,7 +2021,11 @@ static void initialize_tty_struct(struct
  */
 void tty_default_put_char(struct tty_struct *tty, unsigned char ch)
 {
-       tty->driver.write(tty, 0, &ch, 1);
+       int ret = tty->driver.write(tty, 0, &ch, 1);
+       /* This might fail if the lower layer is already full - Jean II */
+       if (ret == 0)
+               printk(KERN_WARNING "Warning: dev (%s) put_char failed\n",
+                      kdevname(tty->device));
 }
 
 /*